The EP Greenhouse gearbox is a compact and lightweight reduction geared motor with a built-in limit switch system that’s ideal for assembly of a locally available electric electric motor. The gear driver is utilized in manually-managed or climate-managed ventilation and screen systems in greenhouses. The quick and easy-to-install EP gearbox is definitely rainproof and windproof. The reducer includes a high protection course (IP65) and can be utilized in an ambient temperature of 0-60 °C.

The low-noise gear reducer for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel transmitting means that the drive shaft is locked when the decrease reducer is not running. The fully sealed reduction reducer comes with an growth chamber with a diaphragm to keep the gear essential oil at a low pressure under all conditions, even at high temperature ranges. Thanks to the utilization of an growth chamber, the gear reducer could be installed in any position. There are no limitations, since there is no dependence on a bleed plug. The sealed reduction geared motor keeps the apparatus essential oil of the gearbox in optimal condition for its entire operating lifetime. The reducer is suitable for discontinuous use, operating class s3-30%, with a maximum activation time of 25 minutes.

The Gear box reduction reducer comes with an FT85 motor assembly flange, on to which a suitable IEC standard motor can certainly be installed (EN 50347).

The Gear box has a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit change system is installed in an integrated chamber and is enclosed by an impact-resistant plastic cover. The limit switch system is accessible and simple to adjust. The limit change system’s optimum switching range is definitely 40 or 64 revolutions of the drive shaft. The cabling is linked in spring-clip connections. The reducer has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.

The gear motor for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates are available as accessories.

Optimum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of program of 4-pole electric motor.
Protection class IP65.
Can be used in ambient temperatures of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, maximum activation time 25 minutes.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC standard motor (EN 50347).
Maximum switching selection of limit switch system 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).