ep

January 22, 2021

SMR Gearbox Installation
Satisfactory effectiveness depends upon right set up. lubrication and servicing. therefore it is important that the guidelines from the set up and maintenance leaflet. supplied with every single gearbox. are followed thoroughly. a few of the significant aspects of belt and torque-arm set up are listed under.
1. Install pulley on gearbox input shaft as near for the reducer attainable, and mount reducer on driven shaft as near to bearing as practical. failure to complete this may induce excess loads in the input shaft bearings and output bearings and could result in their premature failure.
two. Install motor and wedge belt drive with all the belt pull at around 90° to your center line in between driven and input shafts. this will allow tensioning in the wedge belt drive using the torque arm which really should preferably be in tension. if output hub runs anti-clockwise. torque arm really should be positioned the ideal.
3. lnstall torque-arm fulcrum on the rigid assistance so that the torque-arm is going to be at approximately right angles for the center line through the driven shaft along with the torque arm case bolt. ensure there may be adequate consider up inside the turnbuckle for belt stress adjustment.
Retain close.
Bell drive could possibly be located in any effortless postion. should the torque arm is to be employed to tighten the belts, the drive really should be at about tight angle to the line concerning the input and output shafts.
Bell drive may be situated towards the ideal if sought after.
If output hub rotates clock-wise. place belt drive and torque arm in opposite direction to that shown within the illustration.
Torque arm and belt take up.
Torque arm can be mounted to your ideal if sought after.